Water Treatment in Tampa, FL
Free in-home water testing and straight answers for hard water, stains, odor, sediment, and whole-house filtration in Tampa.
City of Tampa 2025 water quality report — every figure is sourced in full below.

What Tampa water looks like
Tampa does not buy its water the way its neighbors do. The city runs its own system — Tampa Water Department, Public Water System (PWS) ID 6290327 — serving more than 733,000 people across the city and parts of unincorporated Hillsborough County, at about 82 million gallons a day. The primary source is the Hillsborough River, treated at the David L. Tippin Water Treatment Facility with ozone and biologically activated carbon, then finished with chloramine. In 2025 the city also pulled 980 million gallons of treated water back out of its aquifer storage and recovery wells, and just 2.7 percent of the year’s water was purchased from Tampa Bay Water. Tampa’s 2025 report — published in 2026, covering January through December 2025 — is a big-city report, and it reads differently from the county systems around it.
The city prints its hardness as an average: 211 parts per million, or 12.3 grains per gallon, for finished water in 2025. On the federal scale, anything over 180 parts per million is “very hard” — so Tampa water is very hard water, full stop, and that is the number behind the scale in Tampa water heaters and the spots on Tampa glass. An average is not your tap, though: river water changes with the seasons and the blend changes with it, which is why the free test measures hardness at your home instead of quoting the system average back at you.
The disinfectant runs at 90 percent of its cap: chloramine’s highest running annual average was 3.6 parts per million against a legal cap (the maximum residual disinfectant level) of 4.0, with individual samples ranging from 0.4 to 5.3. The byproducts are where Tampa’s treatment shows. Total trihalomethanes read 19.0 parts per billion against a limit of 80 — about a quarter of the cap — and haloacetic acids 21.4 against a limit of 60. Ozone and biologically activated carbon pull organic matter out before the chloramine goes in, so less is left to form byproducts. Read it both ways: the byproduct numbers are genuinely good, and the chloramine itself is still there at 3.6 — hard on standard softener resin, and not removed by a softener alone; that takes catalytic carbon with enough contact time.
Lead and copper were sampled twice in 2025, and both rounds were clean. Lead’s 90th percentile — the level 9 out of 10 sampled homes tested at or below — read 0.736 parts per billion in the first half of the year and 1.5 in the second, against a federal action level of 15; copper read 0.287 and 0.253 parts per million against an action level of 1.3. One home in the second-half round did sample above the action level — the range runs to 47.8 — and the report is plain that the 90th-percentile figure is the one the rule judges, and it stayed at 1.5. The city also states its system contains no lead service lines, no galvanized lines requiring replacement, and no lines of unknown material. I will tell you when a number is fine, not just when it is not — and Tampa’s metals numbers are fine.
PFAS (per- and polyfluoroalkyl substances, the “forever chemicals”) is the question everyone asks, and Tampa’s newest report answers it narrowly and honestly: in federal monitoring under the Fifth Unregulated Contaminant Monitoring Rule (UCMR 5), exactly two compounds were detected — PFBS (perfluorobutanesulfonic acid) at 3.0 parts per trillion and PFPeA (perfluoropentanoic acid) at 3.7, both sampled in September 2025 — and the report itself notes those samples were taken at the Morris Bridge facility on water purchased from Tampa Bay Water, not at the Tippin plant. No detected values for PFOA (perfluorooctanoic acid) or PFOS (perfluorooctanesulfonic acid) appear in the report; the federal government set legal limits of 4.0 parts per trillion for those two in 2024, with compliance required by 2029. Older stories quoting bigger Tampa PFAS numbers are not in this report, and this page does not repeat them. On fluoride: Tampa stopped adding it in July 2025 under new state law — the 0.56 parts per million in the table is a May 2025 sample, taken before the change, against a limit of 4.0. Sodium read 51 parts per million against a state standard of 160.
Those are system numbers for three-quarters of a million people. Your tap is one home on the system, with its own pipes and its own water heater. The free 20-minute test covers hardness, iron, chlorine, pH (a measure of acidity), sulfur, and total dissolved solids (TDS) at your tap. Tampa’s published figures are collected in the Hillsborough County water quality results — hardness, chlorine, and the compounds the city report lists. The regional supply behind the whole area — aquifer, reservoir, and desalination — is mapped in where Tampa Bay water comes from.
See what Tampa water is doing in your home.
The free test takes about 20 minutes at your tap. No obligation and no sales pitch — just your numbers, explained against the legal limits.
How we help in Tampa
Sized to your home and your actual test results.
Reverse osmosisDrinking water at the kitchen sink.
Well water treatmentFor iron, sulfur, and sediment.
Other water servicesFilters, UV, and service calls.
What it runs in Tampa
This is a rough range only — your final price could be more or less, depending on your water and your home.
You get one exact written price after the free test, before any work begins. Full breakdown: what water treatment costs, or run the cost estimator.
Licensed & Insured · Locally owned · Owner-installed
Start with the free test
Every recommendation follows a 20-minute test at your tap — never a sales pitch.
The quick water check
Answer a few questions about what your water is doing at home.
Take the 60-second water checkThe free test at your tap
Hardness, iron, chlorine, pH, sulfur, and total dissolved solids — measured at your home, explained on the spot.
Book your free test
Pinellas County, FL